I am trying to figure out if there is a way to scan one side of a part, flip it over and then scan the opposite side of the part. Then take both of the scans and match them together using common points between the scans. I am assuming two COPs need to be made so one can move to the other but I am new to pretty much any measuring software, I am more of a CAD guy but they are starting my training on both a CMM and P-CMM. If it were in a CAD program I would be able to just manipulate where the points are no problem but just can't figure it out using the PC-DMIS software. Any information would be greatly appreciated because I was told it is possible just don't know how to go about it.
Thanks,
Fred
