2011MR1 Win7: non Admin user and app: slow taking points.

I am running PC-DMIS 2011MR1 Win 7 machine and WinRDS 7.1.5 (I have set it up where everyone can change the WAI Reg keys). Security here does NOT allow inspectors to either run with admin rights, or run PC-DMIS with admin rights.

When one of the IT techs logs in with admin rights, this version runs very well. It is better than anything I have seen before. However, if I log in as an inspector, I get problems.

So I am trying to run as a normal user. When I do that, I get sluggish reponse when trying to take points. When I try to take a point, it takes 4 to 10 seconds before PC-DMIS registers the point. I hear the beep, when I press the key. But PC-DMIS screen does not change to the next prompt for some time.

If I wait long enough I can get through my program.

Anybody had this before?

Thanks, Jan.

Parents

DJAMS over 12 years ago

Does WinRDS mean "remote desktop service"? If so, can you explain your system setup?

Edit: to answer your direct question: our operators must login to win7 using normal user accts as well. Pcdmis can not be run with admin priveliges. We do not have this problem on Sheffield or Zeiss interfaces.

Edit2: Was previously on my phone and didn't notice that this was posted in the "portable" forum. I have no experience at all with portable - and my questions above are probably stupid - sorry
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

DJAMS over 12 years ago

Does WinRDS mean "remote desktop service"? If so, can you explain your system setup?

Edit: to answer your direct question: our operators must login to win7 using normal user accts as well. Pcdmis can not be run with admin priveliges. We do not have this problem on Sheffield or Zeiss interfaces.

Edit2: Was previously on my phone and didn't notice that this was posted in the "portable" forum. I have no experience at all with portable - and my questions above are probably stupid - sorry
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data