Your Products have been synced, click here to refresh
To expand to Matthew's comment: when you are creating a Measured Feature of type Point, the probe compensation is dependent on your probehead angle.
Meaning that if you are laying the side of the ball on the top surface, it might be comping in X+/X-/Y+/Y- instead of properly down in Z. This could explain why you're seeing points with a Z-height of about half the 15mm ball.
To expand to Matthew's comment: when you are creating a Measured Feature of type Point, the probe compensation is dependent on your probehead angle.
Meaning that if you are laying the side of the ball on the top surface, it might be comping in X+/X-/Y+/Y- instead of properly down in Z. This could explain why you're seeing points with a Z-height of about half the 15mm ball.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |