Mdobb829 gave me good advice for the CMM however I could not use it, when I tried to follow steps.
Need more help. I added a picture of how the part is set up on table.
Below is how the parts is aligned but actuals do not look right. Something is wrong. If possible, please explain why this alignment is not working. Would creating a point at the intersection of B and A be helpful with this alignment? Using that point as the origin for XY? Then off set Z in -2.63?
Level: B = Z plus
Rotate: C = Y plus
Origins:
X: A
Y: A
Z: B
Thank you for your help
Clementine
Attached Files
