I was having trouble getting diameters to come out correct so I calibrated my probe with a certified sphere. I followed the procedure to the point. It was measuring as much as 1.5mm small, after a few calibrations, I am now measuring .4mm big. My std dev was at .016 and max error at .033. My 15mm and 3mm measure fine, length and point checkout also were fine. I have an Infinite 2.0 with 2012 mr1. Any suggestions?
Have you tried doing a probe calibration using the length standard? That to me always seemed to be easier and successful. I would give that a shot and see how that works if you are still having trouble I would then ask what the probe dropped? Do you have a loose connection? You could also try to reinstall your armspecs.
Have you tried doing a probe calibration using the length standard? That to me always seemed to be easier and successful. I would give that a shot and see how that works if you are still having trouble I would then ask what the probe dropped? Do you have a loose connection? You could also try to reinstall your armspecs.
