I check quite a few formed parts. I've ran into an issue a couple times now and I'm interested if the gurus have any answers, the problem goes as follows:
I setup a part on the table and begin inspection. I take a bunch of vector points that are on the surface of a formed angle (around 35 degrees) when I turn those vector points into a scan and assign it a profile of surface FCF the part is out of tolerance.
I wondered if when I convert the points to a scan if it assigns the scan a workplane and the worklplane caused issues but I tried the same experiment without putting the points into a scan to no avail. Additionally when I check the angles and bend lines the part seems to be right there for the basic dimensions.