mis 2014 software. I am checking the True Position on 1.750" diameter bore. I probed this bore as a cylinder. I went into Legacy Mode and defined my Datums (A,B,C). When going into the advanced button to enter the nominal dimensions for the -X- and -Y- axis. I am also in the current alignment mode. When entering the Nominal dimension for the -X- axis the software takes the dimension. When I enter the Nominal dimension for the -Y- axis the -X- axis converts back to its original value. I went into the Summary mode and corrected the X & Y values, and the software retains these values. When viewing the inspection report the nominal values revert back to the incorrect nominal values. Please Help me correct this issue!!!!.......Thank You
