I tried to create the FCF shown on the print using the Xactmeasure true position, but I had a error message pop up. So I'm just looking for someone to confirm that the print has Bad GDnT.
well I read that true position of a hole referenced back to the plane on which it sits is basically the same thing as perpendicularity. maybe that's what they want to know.
so I figure they want to see if it is in the correct position referenced to Datum ABC but also want to know if it is perpendicular to the plane on which it lays on... QUESTION MARK. at least that's what I'm understanding.
well I read that true position of a hole referenced back to the plane on which it sits is basically the same thing as perpendicularity. maybe that's what they want to know.
so I figure they want to see if it is in the correct position referenced to Datum ABC but also want to know if it is perpendicular to the plane on which it lays on... QUESTION MARK. at least that's what I'm understanding.
