When reporting out true position of a hole it says it's 8 inches out. but if I report out the location of the hole (XYZ) it is in tolerance. My Datum plans are all good also. What am I doing wrong?
what features are you using to set up your alignment?? when reporting true position are you using Xactmeasure or Legacy? if you are using Xactmeasure does your FCF include all 3 Datums or is it just calling out 1 or 2 datums?
what features are you using to set up your alignment?? when reporting true position are you using Xactmeasure or Legacy? if you are using Xactmeasure does your FCF include all 3 Datums or is it just calling out 1 or 2 datums?