FCF callout for hole position with different sized holes

The above callout isn't seeming to work well in pc-dmis and not sure if you gents would even consider this a legal callout. As you can see the FCF references three holes. Two of the holes are .218 - .229" and the third is actually a helicoil thread that has a minor diameter of .201". When I input this into pc-dmis it doesn't really work. Any ideas?

Parents

PacMan23 over 6 years ago

So dimension the 3 holes I labeled in blue jasonsfunderburk
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jasonsfunderburk over 6 years ago in reply to PacMan23

Yeah, i thought of that too pacman... and yes in this particular drawing i would agree if it was a one off. The thing is it's a dash number in a large group of drawings and this is how they call them out. the smaller holes that surround the larger ones are grouped together for the FCF's. I should have given a better example but didn't realize that was how it looked until I had already made the jpg.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

jasonsfunderburk over 6 years ago in reply to PacMan23

Yeah, i thought of that too pacman... and yes in this particular drawing i would agree if it was a one off. The thing is it's a dash number in a large group of drawings and this is how they call them out. the smaller holes that surround the larger ones are grouped together for the FCF's. I should have given a better example but didn't realize that was how it looked until I had already made the jpg.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data