Having difficulty with an alignment

Hello,

I am having difficulty matching the alignment that is shown in the picture below.
I have tried different methods and using different features and just cannot get it right. I'm guessing i will need some sort of constructed line or feature to get the origin to be in space like that?
If anybody can help it would be much appreciated! Thank you!

CB

Attached Files

AndersI over 5 years ago

Without having a print, it's impossible to know which feature(s) are important (or more important than others). A couple of approaches:

Midplane from the inside (or outside) planes -> X level, origin
Cylinder on the bottom shaft - Z rotation
Line/cylinder through the holes, pierce midplane -> Y, Z origin

or

Cylinder on the bottom shaft -> Z level
Line/cylinder through the holes, -> X rotation, Y, Z origin
Midplane from the inside (or outside) planes -> X origin

or

Line/cylinder through the holes, -> X level, Y, Z origin
Cylinder on the bottom shaft -> Z rotation
Intersection of the two lines/cylinders -> X origin

etc.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel