I just have a GD&T question and was hoping you may be able to help. The drawing of a shaft (attached) calls out "1.50 Max Runout." The 1.5 appears to be the measurement from the end of the shaft (1.5 inches). So what is Max Runout? I know what runout is, but is there a standard for Max Runout? Thanks.
I am thinking that this is trying to control the break out end of the tool path, you have a 1.00 min flat , then a Rad for teeth shown
The 1.5 Max runout seems to be controlling the distance of breakout edge of all "teeth" (sharp corner as Shrock stated) to be with in 1.5 of each other
I am thinking that this is trying to control the break out end of the tool path, you have a 1.00 min flat , then a Rad for teeth shown
The 1.5 Max runout seems to be controlling the distance of breakout edge of all "teeth" (sharp corner as Shrock stated) to be with in 1.5 of each other