Dimensioning Torus

I have a question about a measured torus hopefully someone can answer. This is also my first post here, so bear with me

. I've searched a bit but I haven't seen anything that answers my question. Basically, I need to figure out the minor diameter of this torus. If I hover over that feature in the Edit toolbar, under the ACTL measurements I can see the measurement i’m looking for (the .25027). I’m trying to figure out a way to dimension it or manually extract it using a variable or anything related to that. Any suggestions?

Parents

Neil Challinor over 4 years ago

davehocum , I'm not sure I understand your last post correctly?

I added generic features for the outer and inner diameter to your script

My script already creates generic features that represent the major and minor torus diameters.

Pcdmis Feature Location cannot dimension this directly from the Torus

This was precisely the reason for my script in the first place.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Neil Challinor over 4 years ago

davehocum , I'm not sure I understand your last post correctly?

I added generic features for the outer and inner diameter to your script

My script already creates generic features that represent the major and minor torus diameters.

Pcdmis Feature Location cannot dimension this directly from the Torus

This was precisely the reason for my script in the first place.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data