Dimensioning Torus

I have a question about a measured torus hopefully someone can answer. This is also my first post here, so bear with me

. I've searched a bit but I haven't seen anything that answers my question. Basically, I need to figure out the minor diameter of this torus. If I hover over that feature in the Edit toolbar, under the ACTL measurements I can see the measurement i’m looking for (the .25027). I’m trying to figure out a way to dimension it or manually extract it using a variable or anything related to that. Any suggestions?

Parents

Dave Hocum over 3 years ago

I added the largest outer and the smallest inner diameter. I have measured a boss feature with the top edge radius of the boss intersecting the surface the boss extrudes from. The print will ask for the dimension of the diameter of the boss. This feature illustrated here is what I used for the Torus example.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Dave Hocum over 3 years ago

I added the largest outer and the smallest inner diameter. I have measured a boss feature with the top edge radius of the boss intersecting the surface the boss extrudes from. The print will ask for the dimension of the diameter of the boss. This feature illustrated here is what I used for the Torus example.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data