Scanning flatness is a specified area

We need to scan a surface with a hole in it and measure the flatness in a specified radius around the hole. Is there a way to set the radius so that only the specified area is reported instead of the entire scanned surface?

Parents

RandomJerk over 3 years ago

Alternately, use autofeature to measure a plane using the radial option and set that up per your specification, report that.

Then scan the rest of the surface, construct a plane out of the two scans, and now you have your entire surface.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

RandomJerk over 3 years ago

Alternately, use autofeature to measure a plane using the radial option and set that up per your specification, report that.

Then scan the rest of the surface, construct a plane out of the two scans, and now you have your entire surface.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data