This is the error message I keep getting when I execute my scan for my part. It allows be to complete the execution despite this message however all of my executions have given me bad data. I'm assuming this is probably an issue with my code? Or maybe I have some of my settings off a bit. Any suggestions help!
This is the error message I keep getting when I execute my scan for my part. It allows be to complete the execution despite this message however all of my executions have given me bad data. I'm assuming this is probably an issue with my code? Or maybe I have some of my settings off a bit. Any suggestions help!
By "bad data" I mean measurements out of tolerance by 10-20 inches
So what I found my issue to be was a setting that is only editable in edit mode. I was getting the no laser stripes error when I tried to extract a basic plane without CAD model. There's a setting that is not in the autoplane extraction dialog. There is a line of code that says CAD segregation = on/off. It defaults to on even when there isn't a model imported. Toggle it to off and you're back in business
