Is it possible to manipulate the "Any order execute tolerance" setting in the code of the program? I generally WANT this feature, but there are some programs where I KNOW it's going to cause an issue for a particular edge or point and it would be great to toggle it to zero and then back to 10 in the code of the program, without having to stop, change the setting, then run from the cursor point, then stop and change it back.
I searched around but couldn't find this particular question answered already.
I don't think so - it's a setting rather than a command. It could maybe done via automation as it's likely a registry setting, but I would assume the registry setting is read in at the start of execution and not repeatedly during execution.
I don't think so - it's a setting rather than a command. It could maybe done via automation as it's likely a registry setting, but I would assume the registry setting is read in at the start of execution and not repeatedly during execution.