My company is starting to look into alternative inspection software to try and speed up the programming process so we can get things checked and out the door quicker. With PC-DMIS, I feel like I'm spending hours programming a part just to spend a few minutes inspecting it and it feels like there's got to be a better way. I used Verisurf at my old job and loved it. My boss started looking into it and found Inspire. It looks promising, but it's so hard to find information on it outside the Hexagon sales gimmick to learn from any actual information about it. does anybody here have any first hand experience with it, and is it preferable with a Romer Arm over PC-DMIS?
My company is starting to look into alternative inspection software to try and speed up the programming process so we can get things checked and out the door quicker. With PC-DMIS, I feel like I'm spending hours programming a part just to spend a few minutes inspecting it and it feels like there's got to be a better way. I used Verisurf at my old job and loved it. My boss started looking into it and found Inspire. It looks promising, but it's so hard to find information on it outside the Hexagon sales gimmick to learn from any actual information about it. does anybody here have any first hand experience with it, and is it preferable with a Romer Arm over PC-DMIS?
What aspect of doing it with PC-Dmis seem slow, perhaps there's some techniques you don't know about that might make things quicker.
What sort of things are you measuring, and how are you measuring them?
I assume you know about point only mode/find noms/update noms during execution? I find it incredible quick on an arm.
My company is starting to look into alternative inspection software to try and speed up the programming process so we can get things checked and out the door quicker. With PC-DMIS, I feel like I'm spending hours programming a part just to spend a few minutes inspecting it and it feels like there's got to be a better way. I used Verisurf at my old job and loved it. My boss started looking into it and found Inspire. It looks promising, but it's so hard to find information on it outside the Hexagon sales gimmick to learn from any actual information about it. does anybody here have any first hand experience with it, and is it preferable with a Romer Arm over PC-DMIS?
What aspect of doing it with PC-Dmis seem slow, perhaps there's some techniques you don't know about that might make things quicker.
What sort of things are you measuring, and how are you measuring them?
I assume you know about point only mode/find noms/update noms during execution? I find it incredible quick on an arm.
