I had a couple questions currently my employer uses another software for laser scanning with a LLP but I am trying to explain to them since we use PCDMIS for the CMM we should also use it for the arm it would make everything more uniform measuring the same parts as far as reporting, alignments etc.. They seem to be hung up on the pretty color maps and 3d deviation points of polyworks or geomagic, i was wondering if any of you on here could enlighten me of some good looking reports with color maps, annotation points etc from a portable arm I can use as ammunition to get them to come around, i would really appreciate it even if its on the the hexagon block just something since i dont have the license for a portable arm to be able to show this.
So that photo in a report is really the only difference ? i was also wondering about annotations, or taking the T value of points on the scan data is that possible where pcdmis will just extract a vector that you dont have to probe and you can report the T value like you sort of would on the cmm? Also how do you clean noise/filter pointclouds when your using a romer arm just boolean?
So that photo in a report is really the only difference ? i was also wondering about annotations, or taking the T value of points on the scan data is that possible where pcdmis will just extract a vector that you dont have to probe and you can report the T value like you sort of would on the cmm? Also how do you clean noise/filter pointclouds when your using a romer arm just boolean?
