I have a profile that I made out of point into a scan set. The scan set is in the Z- ( below plane A that I set my z axis to) how can I get 2 positive vectors with the rest being negative? Made sure I was pointing my gun as straight up as I could? I am at a loss and have an engineer looking at me sideways.
The following will show the XYZ and IJK of your CAD data as the alignment changes or the cursor is moved across the CAD suface.
Turn on the Probe Readout window (Ctrl + W)
Right Click on the Window and a settings button will appear.
Click on the settings button.
Lower Left Corner of the Probe Readouts setup dialog has two checkboxes; Show CAD and Show Part
Click on the two checkboxes.
Now when you run your cursor over the model, CAD and Part XYZ IJK's will be continuously displayed in real time.
If you want/need more resolution then you can change the DISPLAYPRECISION parameter. (Edit/ Preferences/ Setup/ Dimension Tab/ Number of decimal places.
The following will show the XYZ and IJK of your CAD data as the alignment changes or the cursor is moved across the CAD suface.
Turn on the Probe Readout window (Ctrl + W)
Right Click on the Window and a settings button will appear.
Click on the settings button.
Lower Left Corner of the Probe Readouts setup dialog has two checkboxes; Show CAD and Show Part
Click on the two checkboxes.
Now when you run your cursor over the model, CAD and Part XYZ IJK's will be continuously displayed in real time.
If you want/need more resolution then you can change the DISPLAYPRECISION parameter. (Edit/ Preferences/ Setup/ Dimension Tab/ Number of decimal places.
