Looking at buying a new Romer or FARO Arm. Trying to decide on length, probably a 10' or 12', to replace an 8'. Does anybody have regrets going too long/large? I know the accuracy is slightly lower and they are a bit more "clunky" to use. Is there any other downside you can think of?
My rule of thumb for buying the first of any 3D measuring equipment is to go
at least one size bigger than what I think I'll need. Nothing sucks more than to go to war for a piece of equipment and then 6 months later a new part comes in that is bigger than anything else you wanted to measure with that equipment. As long as accuracy and space is not an issue, bigger is better in my opinion.
Having said that, is an arm your best option? I've never used one besides a demo but I used to hear a lot about them gathering dust in the corner because of accuracy and repeatability issues. Don't know if that has improved or not.
My rule of thumb for buying the first of any 3D measuring equipment is to go
at least one size bigger than what I think I'll need. Nothing sucks more than to go to war for a piece of equipment and then 6 months later a new part comes in that is bigger than anything else you wanted to measure with that equipment. As long as accuracy and space is not an issue, bigger is better in my opinion.
Having said that, is an arm your best option? I've never used one besides a demo but I used to hear a lot about them gathering dust in the corner because of accuracy and repeatability issues. Don't know if that has improved or not.
