Hey fellas, been getting very comfortable with my 8725 and AS1 but I'm struggling a little to create good meshes. What's the secret? I've tried all 3 standard filters. Still objects don't seem to resemble my part. Wayyy to many triangles. Does PCDMIS even have the ability to reverse engineer objects? Mine don't look near as fluid and smooth as the videos I watch with polyworks or other softwares. Any advice?
They are designed to give better edge and curvature definition whilst minimising the number of triangles on flat surfaces. In our testing and benchmarking against our leading competitors, we found that we out-performed them on several key metrics...
our mesh quality was better (less noise, better defined edges and radii, better able to capture fine detail)
Less need for manual intervention (hole filling etc)
calculation times were faster (3x faster than leading competitor)
the mesh file size was smaller (between 3 and 10 times lighter file size)
They are designed to give better edge and curvature definition whilst minimising the number of triangles on flat surfaces. In our testing and benchmarking against our leading competitors, we found that we out-performed them on several key metrics...
our mesh quality was better (less noise, better defined edges and radii, better able to capture fine detail)
Less need for manual intervention (hole filling etc)
calculation times were faster (3x faster than leading competitor)
the mesh file size was smaller (between 3 and 10 times lighter file size)