We got a new 3mm probe for our Romer arm. Someone else here says that they calibrated the probe and that it was ready for use. I keep getting an error saying "Unknown probe file: Romer_Probe4. Check usrprobedat." This error occurs in PCDMIS. I've gone back thru the directions to install the probe as if it hasn't been done yet but I still have the error. Does anyone know what is going wrong? Any suggestions will be appreciated.
It sounds like the probe is not being recognized by WinRDS.
Try performing a search for the "usrprobedat" file, it will more than likely be in the WinRDS folder.
If it's not there, your best bet is to contact tech support.
It sounds like the probe is not being recognized by WinRDS.
Try performing a search for the "usrprobedat" file, it will more than likely be in the WinRDS folder.
If it's not there, your best bet is to contact tech support.