Dear forum members, does anybody can share his/her experience of round parts alinment when using a portable arm? I tried to align tube with two rounded slots and through holes but each time I faced with inversion of two coordinates after alignment - when moving probe in x+ or z+ ditection it translated in x- or z- direction accordingly in pc dmis interface. I have no any idea what should I start from to prevent this inversion. Please help.
I tried to set alignment today, and from the 3rd alignment part was found correctly (all steps listed in attached file). When part be aligned 2 issues to be solved:
1) to align part with round slots oriented perpendicularly to the table surface,
2) to change vector direction in plane settings (F9) if inversion in probe movement has been found (Z- instead of Z+, X- instead of X+)
I tried to set alignment today, and from the 3rd alignment part was found correctly (all steps listed in attached file). When part be aligned 2 issues to be solved:
1) to align part with round slots oriented perpendicularly to the table surface,
2) to change vector direction in plane settings (F9) if inversion in probe movement has been found (Z- instead of Z+, X- instead of X+)
. When part be aligned 2 issues to be solved:
