I have a Visio 300
PC-DMIS 4.3
I set up 2 gage blocks side by side 1 .600" and 1 .550"
I measured a the top of the .600" block with an auto focus point max zoom
set the (Z) origin to that point
measured the same point 10 times and got a range of .00222"
did the same on the .550" block and got a range of .00247"
I don't understand I feel this should be more accurate than this.
Does anyone have any settings suggestions that I can try?
Thanks
Try increasing the duration of the focus. You should also be on high magnefication. Also try turning the light down. Use the light ring, it is less shiny than the top light. Also turn the light down.
Try increasing the duration of the focus. You should also be on high magnefication. Also try turning the light down. Use the light ring, it is less shiny than the top light. Also turn the light down.