I have a Visio 300
PC-DMIS 4.3
I set up 2 gage blocks side by side 1 .600" and 1 .550"
I measured a the top of the .600" block with an auto focus point max zoom
set the (Z) origin to that point
measured the same point 10 times and got a range of .00222"
did the same on the .550" block and got a range of .00247"
I don't understand I feel this should be more accurate than this.
Does anyone have any settings suggestions that I can try?
Thanks
Also tested these:
plastic .00216 range
phenolic .00249 range
steel grind finish .0025 range
steel tumbled finish .00379 range
steel lapped finish .00216 range
brass turned finish .00242
TOP SURFACE=FEAT/VISION/SURFACE POINT,CARTESIAN
THEO/<0,0,0>,<0,0,1>
ACTL/<0.00201,0.00131,0.00084>,<0,0,1>
TARG/<0,0,0>,<0,0,1>
SNAP=NO
SHOW FEATURE PARAMETERS=NO
SHOW_VISION_PARAMETERS=YES
TYPE=AUTOMATIC HIT TARGET
MAGNIFICATION=4.51213
HIT TARGET COLOR=WHITE,NOMINAL COLOR=GREEN
HIT TARGET=SA1,YES,0.01721,0.01525
FOCUS=FULL,0.4,NO,6,NONE,NO,TOP LIGHT [OFF] : BOTTOM LIGHT [OFF] : RING
LIGHT [ON:89%{1111}]
DIM LOC1= LOCATION OF POINT TOP SURFACE UNITS=IN ,$
GRAPH=OFF TEXT=OFF MULT=200.00 OUTPUT=BOTH
AX NOMINAL MEAS
X 0.00000 0.00201 ----#---
Y 0.00000 0.00131 ----#---
Z 0.00000 0.00084 ----#---
END OF DIMENSION LOC1
Also tested these:
plastic .00216 range
phenolic .00249 range
steel grind finish .0025 range
steel tumbled finish .00379 range
steel lapped finish .00216 range
brass turned finish .00242
TOP SURFACE=FEAT/VISION/SURFACE POINT,CARTESIAN
THEO/<0,0,0>,<0,0,1>
ACTL/<0.00201,0.00131,0.00084>,<0,0,1>
TARG/<0,0,0>,<0,0,1>
SNAP=NO
SHOW FEATURE PARAMETERS=NO
SHOW_VISION_PARAMETERS=YES
TYPE=AUTOMATIC HIT TARGET
MAGNIFICATION=4.51213
HIT TARGET COLOR=WHITE,NOMINAL COLOR=GREEN
HIT TARGET=SA1,YES,0.01721,0.01525
FOCUS=FULL,0.4,NO,6,NONE,NO,TOP LIGHT [OFF] : BOTTOM LIGHT [OFF] : RING
LIGHT [ON:89%{1111}]
DIM LOC1= LOCATION OF POINT TOP SURFACE UNITS=IN ,$
GRAPH=OFF TEXT=OFF MULT=200.00 OUTPUT=BOTH
AX NOMINAL MEAS
X 0.00000 0.00201 ----#---
Y 0.00000 0.00131 ----#---
Z 0.00000 0.00084 ----#---
END OF DIMENSION LOC1