I have 2010MR3 and 2011 on the PC. I can calibrate the CMM-V with no error on 2010MR3. I built the same probe on 2011, and the calibration stop with this kind of message : "Focus detection error in one position".
I have only two choices : retry or cancel. If I retry, it's the same, if I cancel, the probe is not calibrated !!!!!
What can I do ?
(I prefer 2011 for some fixed bugs on tool changer...)
Not at all... I search the differences between the two versions. I found out that the 2 CMM-Ve are still presents in the probe.dat (and I don't understand why).
The major problem that I found this afternoon is in the setting editors : the parameter of camera is not read from 2010MR3 to 2011. It's a parameter that describe the type of wire and the type of video that you have (BNC + PAL in my config). I setted this parameter in 2010 MR3 to "3", but It stayed at "1" when I installed 2011. I will know it next time !!!!!
Not at all... I search the differences between the two versions. I found out that the 2 CMM-Ve are still presents in the probe.dat (and I don't understand why).
The major problem that I found this afternoon is in the setting editors : the parameter of camera is not read from 2010MR3 to 2011. It's a parameter that describe the type of wire and the type of video that you have (BNC + PAL in my config). I setted this parameter in 2010 MR3 to "3", but It stayed at "1" when I installed 2011. I will know it next time !!!!!
