I have 2010MR3 and 2011 on the PC. I can calibrate the CMM-V with no error on 2010MR3. I built the same probe on 2011, and the calibration stop with this kind of message : "Focus detection error in one position".
I have only two choices : retry or cancel. If I retry, it's the same, if I cancel, the probe is not calibrated !!!!!
What can I do ?
(I prefer 2011 for some fixed bugs on tool changer...)
Thanks, racerx00 !
I have focus pulse =16, framegrabber type = 2, framegrabber camera type = 3...In interface setup, I think it's ok.
Where did you find those settings ?
What video card do you use (I think mine is cronos +, so framegrabber type = 2)
Can i change without problems ???????
Thanks, racerx00 !
I have focus pulse =16, framegrabber type = 2, framegrabber camera type = 3...In interface setup, I think it's ok.
Where did you find those settings ?
What video card do you use (I think mine is cronos +, so framegrabber type = 2)
Can i change without problems ???????