I have 2010MR3 and 2011 on the PC. I can calibrate the CMM-V with no error on 2010MR3. I built the same probe on 2011, and the calibration stop with this kind of message : "Focus detection error in one position".
I have only two choices : retry or cancel. If I retry, it's the same, if I cancel, the probe is not calibrated !!!!!
What can I do ?
(I prefer 2011 for some fixed bugs on tool changer...)
Our card is a National Instruments. We are running a 64bit pc and this was a special card for that. The settings I use are what they told me when they installed everything. So you may need to get ahold of tech support to verify your settings are correct. But even if you change them, you can always change them back. Just write down what they were to begin with. I will try and keep thinking if there is anything else.
Our card is a National Instruments. We are running a 64bit pc and this was a special card for that. The settings I use are what they told me when they installed everything. So you may need to get ahold of tech support to verify your settings are correct. But even if you change them, you can always change them back. Just write down what they were to begin with. I will try and keep thinking if there is anything else.
