I am trying to cal a Mycrona using PcDmis Vision and it keeps wanting me to line up with a retangular target. I have centered on i think every target possible. I would really appreciate any help with this. Thanks all.
Mycrona Signum RL
PcDmis Vision 4.3mr1
Hexagon Calibration scale
Here is a pic of where to line up the rectangular targets. I usually focus and center on these targets before i even bring up the calibration, but have also done it without being on the targets also. Do the illumination first then optics then probe offset. if you have mulitsensors you will also have to do probe offset, but that is last. hopefully some of this helps.
Here is a pic of where to line up the rectangular targets. I usually focus and center on these targets before i even bring up the calibration, but have also done it without being on the targets also. Do the illumination first then optics then probe offset. if you have mulitsensors you will also have to do probe offset, but that is last. hopefully some of this helps.
