I have a problem where if I run a program with my vision tip only it asks for a probe file and no matter what probe or no probe attached it will just keep looping and asking the same question. Have to end task on pc-dmis to get out of it.
Has anyone seen this or have any ideas?
I'm new to CMMs and vision so it might be something easy that I just don't know.
I got a work around.
From probe utilities, Setup then checked "Don't ask operator for currently loaded probe file when using a probe changer"
I just have to make sure I got the right probe on.
I got a work around.
From probe utilities, Setup then checked "Don't ask operator for currently loaded probe file when using a probe changer"
I just have to make sure I got the right probe on.