Hello,
I am new to vision measurement with pc dmis. I was trying to verify that the vision and touch probe measure the same and am coming up with issues that I am not sure about how to correct.
The touch probe seems to be measuring good and true to itself, but when i measure the same ring gage in the same location with the vision I get a deviation of (-0.0033) in X, a deviation of 0.0063 in Y, a deviation of (-.0052) in Z, and a deviation of (-.0012) on the diameter.
I am running 2011 MR1 on a optiv performance 2z443.
Are there simple offsets that I can use? Should I just try to run the machine through calibration again?
The only calibration that I have done is optical to ring (yes has moved) - probe to ring (has not moved) - probe to sphere (yes has moved)
The probe seems to repeat to itself and the optical to itself, but they dont repeat to eachother. The optical is also giving a smaller diameter than the ring measures.
Any help would be greatly appreciated. I am on my second week of work here and would really like to get there machine up to par. I will not be able to go for formal training for about two months and this machine is needed to be running yesterday.
Thanks again for any help
