Alignment issues. Pleeease help!!

hello everyone,

I'm new to the PC-DMIS programming and here's my issue.

I have a part programmed and works fine. Now I've added a new fixture to the machine that requires the part to be rotated 45 degrees.
I have tried to adjust my alignment and Yline but it still thinks all my features are at the old position before adding that new fixture. How can I fix this and be able to measure all my parts without having to reprogram?

Thanks in advance!

Parents

D-Train over 10 years ago

So is it getting measured then turned 90 degrees??? Or is it just turned from the original position 90 degrees? If its just getting turned from original, then all you would have to do is change the tip angles, granted the workplane is in the Z. If it is in the Y or X workplane then that has to be changed.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

D-Train over 10 years ago

So is it getting measured then turned 90 degrees??? Or is it just turned from the original position 90 degrees? If its just getting turned from original, then all you would have to do is change the tip angles, granted the workplane is in the Z. If it is in the Y or X workplane then that has to be changed.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data