I am using the Dual Z 443 with PC-DMIS 2013 MR1 SP6, and I am really confused with the Vision Offset Calibration Order.
Is it a must to calibrate the vision first then touch or is it ok to calibrate the touch first?
Once a while I check the vision-touch offset and the touch-touch offset, sometimes the vision-touch offset goes wrong, while
the touch-touch offset is ok, if i calibrate the vision-touch offset with the vision first, at this moment will the touch-touch offset
goes wrong? If so, will it be possible if I calibrate the touch first then vision to save time and make sure all the offset is good?
Nice post, Eva !
But be carefull on 2014SP2, I think answering yes isn't enough to zero offsets (Don't know about vision cmm, I can't check it !). You have to "reset to theo values" AND answer Yes...
Nice post, Eva !
But be carefull on 2014SP2, I think answering yes isn't enough to zero offsets (Don't know about vision cmm, I can't check it !). You have to "reset to theo values" AND answer Yes...