Lately, while in manual mode, the vision measurement tool is not appearing. You are asked to "align hit target" with your feature, but there is no hit target to measure with.
This tends to happen when I program on a model. Then during execution, the hit target is way out in space. In manual, the hit target should move with me, should it not? If I move to take the feature off the part, then the part no longer lines up with the model.
I don't use CAD models so it's difficult for me to answer that. When you say "In manual..." are you talking about manual mode as opposed to DCC mode or a manual hit target as opposed to an automatic hit target?
This tends to happen when I program on a model. Then during execution, the hit target is way out in space. In manual, the hit target should move with me, should it not? If I move to take the feature off the part, then the part no longer lines up with the model.
I don't use CAD models so it's difficult for me to answer that. When you say "In manual..." are you talking about manual mode as opposed to DCC mode or a manual hit target as opposed to an automatic hit target?
