Don't break the calibration chain!
I am posting this in hopes to have it made into a sticky since I see this issue arise a lot in the Vision section. This document perfectly explains the calibration process for calibrating offset with a Vision primary system with TTP.
Oh that is awesome! Thanks for sharing. I am assuming if I want to add in my tactile tips sitting in my tool changer just to add machine coordinate move points. Then the tips with the tool changer location is already loaded so it should know where to go.
After I get a chance to sit down and program my auto cal routine I will share as well.
I am also going to take a chance and see if I can integrate my white light sensor probe scripting routine in with the auto cal for my Vision and TTP.
Oh that is awesome! Thanks for sharing. I am assuming if I want to add in my tactile tips sitting in my tool changer just to add machine coordinate move points. Then the tips with the tool changer location is already loaded so it should know where to go.
After I get a chance to sit down and program my auto cal routine I will share as well.
I am also going to take a chance and see if I can integrate my white light sensor probe scripting routine in with the auto cal for my Vision and TTP.
