White light sensor settings

Hi,

Yesterday the Optiv machine gave very strange values with the white light sensor. It recently gave me some problems with making surface points. The white light did not measure it, so I went on and changed the 'set detection treshold' value, which was on 205, to 80. I saved this setup and it worked perfectly well for a day, but then it started to give me strange values such as 0.4 out of tol for the flatness. My frequency is set on 320 Hz.

I would love to hear a solution for this, as I have to wait a week for the troubleshooter and the machine cannot be used in the meanwhile.

Mihael

Parents

MihaelR over 7 years ago

Hi Rick,

Thanks for the response. I found the problem today. I had to restart the machine when I changed the values in the settings.

Ihave the same Chrocodile, and I found that in the book as well. We use a frequency at 320, but that depends on your product.

Mihael
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

MihaelR over 7 years ago

Hi Rick,

Thanks for the response. I found the problem today. I had to restart the machine when I changed the values in the settings.

Ihave the same Chrocodile, and I found that in the book as well. We use a frequency at 320, but that depends on your product.

Mihael
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data