PC-DMIS CAD x64 Versions crashes

Hi to all,
I am running PC-DMIS CAD 2017 R1 SP8 (x86) on all our Optiv classic 443s, I have installed 2017 R2 x64 version and it installs OK but when I run it it crashes, tried with 2018 R1 SP3 and it also crashes. Any help would be appreciated, thanks.

Parents

InspectorJester over 6 years ago

This is a whole can of worms, sir.
Getting an Optiv up and running alone is a BlTCH.
Have you contacted a Hex-a-Tech to Czech out the situation?

There's too many variables involved to get by without their help.
Do you have all of the right DLL's? Did you install the Vision Interface? Did you backup/restore the settings editor? Did you make note of any file location changes between x86 and x64? Etc, etc, etc..
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
InspectorJester over 6 years ago in reply to InspectorJester

You would need to contact someone from Hexagon to take a look.
It depends on the framegrabber, machine, how much money you put into it, etc.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

InspectorJester over 6 years ago in reply to InspectorJester

You would need to contact someone from Hexagon to take a look.
It depends on the framegrabber, machine, how much money you put into it, etc.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data