I am using an Optiv 543. Using the camera, I am trying to create a curve to use for a 2d profile. I managed to use auto profile 2d to measure a curve, but when I plug that curve into the line profile characteristic. I get no deviation, and there should be at least .001" Also the curve I did measure would have <50% point coverage on High. I would get 100% point coverage on Low.
Using an Optiv 543. I need to measure (scan) an edge to evaluate profile using the
camera. I created a curve using the clipping plane, when I open the "Auto profile
2d" and select the curve, I get the whole curve. I only need a small segment of the
curve. How do I select just the segment I want?
Using an Optiv 543. I need to measure (scan) an edge to evaluate profile using the
camera. I created a curve using the clipping plane, when I open the "Auto profile
2d" and select the curve, I get the whole curve. I only need a small segment of the
curve. How do I select just the segment I want?
