2D Feature on 3D CAD File

Hello!
Running PC-DMIS 2018R2
----------------------------------------
I have a 3D CAD file (STEP) that I need to get a corner radius from. The way it's drawn, PC-DMIS wants to draw a circle in Y, along a neckdown, whereas I need a circle in Z, where the neckdown meets a land.
I am unable to "point and click" for this; it wouldn't be an issue, as I could probably math everything out, but PC-DMIS crashes every time I try to use a Vision circle (for whatever reason) but works if a create a 2D Profile, a Feature Set, and construct a circle from that.

I'm trying to make sure my nominals for the scan are correct, and PC-DMIS won't just snap to that feature.
Any suggestions?

Parents

bfire85 over 5 years ago

Are you able to grab a CAD edge from another area and adjust the nominals that way?

When you say it crashes, what do you mean? When you select the auto circle? When you create the feature? When you try running it?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

bfire85 over 5 years ago

Are you able to grab a CAD edge from another area and adjust the nominals that way?

When you say it crashes, what do you mean? When you select the auto circle? When you create the feature? When you try running it?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

InspectorJester over 5 years ago in reply to bfire85

I am able to use print dimensions for an auto circle, but not a 2D profile.
It crashes when I execute the feature; presumably due to it being a small arc...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bfire85 over 5 years ago in reply to bfire85

InspectorJester Does it crash in full execution or when you do a CTRL+E? How small of an arc? Can you post a snippet of the CAD and area in question, presumably with the auto feature dialog box open so I can see the target hits?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
InspectorJester over 5 years ago in reply to bfire85

I doubt I can post anything; a 1mb image is too big for the server, apparently...

It crashes regardless of how I run the part, CTRL+E, CTRL+U, CTRL+Q, typically when I try to measure too small of an arc on an Auto Circle feature. The arc is less than 90°, sometimes less than 45, so I'm not entirely surprised it would have trouble calculating...
EDIT:
I will have to post or email something later, as I have work to do outside of that program, but I will get back to you on that
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel