CMMV + rotary problem (long time ago...)

Measuring surface points with the cmmv, rotary angle = 0, all is fine.
Rotary angle different of zero, the measured point is shifted, but a read point after autpopoint is right.
I check the values by inserting a move point after the autopoint at its coordinates...
Could it be a bug ?????

JEFMAN over 3 years ago

Change the controller, update to 2020R1 SP12, nothing changed... !
I believe that the cmmv vector doesn't understand the rotary rotation...

neil.challinor ?
Don Ruggieri ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Neil Challinor over 3 years ago in reply to JEFMAN

What controller is it - FDC or something else?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Neil Challinor over 3 years ago

If it is the FDC SLC then check : https://docs.hexagonmi.com/pcdmis/2020.2/en/helpcenter/index.htm?rhcsh=1&rhnewwnd=0#t=mergedProjects%2Fmiim%2FFDC-SLC%2FInterface-Specific_Options_FDC_SLC.htm

If it is the FDC - visionbox check : https://docs.hexagonmi.com/pcdmis/2020.2/en/helpcenter/index.htm?rhcsh=1&rhnewwnd=0#t=mergedProjects%2Fmiim%2FFDC-VisionBox%2FInstallation_Information.htm
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JEFMAN over 3 years ago

neil.challinor
New one is DC 800, old one was B6 CS.

Thanx for the links, I will check parameters.
Happy week-end, all !!!!!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JEFMAN over 2 years ago

Using 2022.1SP2 : not fixed !!!!!
In addition, the move to clear plane is not perp to the clear plane, it goes with an angle (but don't know which one, it depends on the rotary angle !)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel