CMMV + rotary problem (long time ago...)

Measuring surface points with the cmmv, rotary angle = 0, all is fine.
Rotary angle different of zero, the measured point is shifted, but a read point after autpopoint is right.
I check the values by inserting a move point after the autopoint at its coordinates...
Could it be a bug ?????

Parents

Neil Challinor over 3 years ago

If it is the FDC SLC then check : https://docs.hexagonmi.com/pcdmis/2020.2/en/helpcenter/index.htm?rhcsh=1&rhnewwnd=0#t=mergedProjects%2Fmiim%2FFDC-SLC%2FInterface-Specific_Options_FDC_SLC.htm

If it is the FDC - visionbox check : https://docs.hexagonmi.com/pcdmis/2020.2/en/helpcenter/index.htm?rhcsh=1&rhnewwnd=0#t=mergedProjects%2Fmiim%2FFDC-VisionBox%2FInstallation_Information.htm
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Neil Challinor over 3 years ago

If it is the FDC SLC then check : https://docs.hexagonmi.com/pcdmis/2020.2/en/helpcenter/index.htm?rhcsh=1&rhnewwnd=0#t=mergedProjects%2Fmiim%2FFDC-SLC%2FInterface-Specific_Options_FDC_SLC.htm

If it is the FDC - visionbox check : https://docs.hexagonmi.com/pcdmis/2020.2/en/helpcenter/index.htm?rhcsh=1&rhnewwnd=0#t=mergedProjects%2Fmiim%2FFDC-VisionBox%2FInstallation_Information.htm
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data