Your Products have been synced, click here to refresh
so with this readpoint alignment, does the operator have to physically take the manual point, or just place the probe in the area described?
Also does the readpoint work with parts that have datum targets? I must not be doing this right but it doesn't seem to work to well. I place the probe above the part about one inch, and centered on a hole, thats in the Z plus, this hole is also a known distance from the datum targets that are in the Y minus. But when I go to add an auto pnt on the Y1 datum, it is not in the Y location that it should be according to the print, it is off by 3mm.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |