alignmet whit 4 features or more for plane

Hi every one!!

I have a doubt, how can i made an iteractive alignment with 4 features or more to make plane, two for line, and one for origen?...i mean not 321.. but rather, three o more for the plane?

could be that all the plane it become in zero after the alignment?
or , how i can do that?..with four features?

thanks in advance !!

Parents

whisho over 12 years ago

You can use as many features as you want for an iterative alignment. Unless the part is perfect, you will see error, Pcdmis will balance the error out. So if you are using 4 for the level, you might see two of them at -0.023 and two of them at +0.023 or whatever it happens to be. It will be balanced, it will not be perfect (because there are no perfect parts).

so, due that it will be balanced, no problem with the results?..are fine..isn't wrong?..can I use and shared that data without problem and take desicions?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

whisho over 12 years ago

You can use as many features as you want for an iterative alignment. Unless the part is perfect, you will see error, Pcdmis will balance the error out. So if you are using 4 for the level, you might see two of them at -0.023 and two of them at +0.023 or whatever it happens to be. It will be balanced, it will not be perfect (because there are no perfect parts).

so, due that it will be balanced, no problem with the results?..are fine..isn't wrong?..can I use and shared that data without problem and take desicions?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data