Does anyone know how to have PC-DMIS plot flatness result? We do this on other software and would like to do it on this software as well. It so we can see the contour, ie. dish, dome, potato chip. With this the machinists can determine the best route to bring the part into spec. Right now for example we have a part the is approximately 13" round and is dished on one side and domed on the other. All this is seen via the plot. All help is much appreciated.
I can barely see the images. It looks to me like you just need to play around with the dimension options that Anders mentions in step 3. If you want you can turn deviation arrows on and off, increase the multiplier to make them more visible, show or hide the tolerance zone, etc. Of course, it will never look exactly like some other software but I would be surprised if you can't get a display that is just as useful.
I can barely see the images. It looks to me like you just need to play around with the dimension options that Anders mentions in step 3. If you want you can turn deviation arrows on and off, increase the multiplier to make them more visible, show or hide the tolerance zone, etc. Of course, it will never look exactly like some other software but I would be surprised if you can't get a display that is just as useful.
