Hello, I'm new to this forum, so any and all suggestions and help is greatly appreciated. I work during the day with pc dmis 2010 MR3. I accepted a side job not knowing that older software is being used. Now to my point.
the CMM with 3.7 is a brown and Sharp one 775 with a non motorized probing head. My question is how do I calibrate and add tips in 3.7... I have done some research and found that there is a PH9 setting where the tips go... but Im not sure how to put a change tip command in my program or how best to create and calibrate other tips needed.
thanks a bunch.
