Measuring problem

Hello,
i have a problem, i have the probe to A0 B0 , then i do the alignment and measure the dimension and everything is fine, but then i need to turn the probe to A0 B90 or 180 and measure, the dimension are not ok, they are totally wrong +-1,5mm more or less, i have all the angles calibrated, what am i doing wrong? Please help
Sorry for mu bad english

WilliamL over 1 year ago

Can you post some of your code you used and the results of the measurements you're concerned with? Please be sure to use code tags with your code when sharing.

Also I believe this may be the wrong forum for this, but I am not sure.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Beck's over 1 year ago

is your probe calibrated correctly?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JEFMAN over 1 year ago

Do you use a "L" shape probe ?
You should load your master probe, the calibrate it saying yes, the sphere moved (with rest to theo selected), then load the L probe, and calibrate both angles saying No, the sphere don't moved.
You could create a parameter set and then autocalibrate the probes with it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bfire85 over 1 year ago

Did you calibrate the A0B0 and then calibrate the tip change? Every tip needs to be calibrated.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
DAN_M over 1 year ago

Check out Post#2 here: https://www.pcdmisforum.com/forum/pc-dmis-enterprise-metrology-software/pc-dmis-for-cmms/536471-calibrating-multiple-tips#post536474
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel