Hello, all!
(I'm ignorant. Tear me apart!)
This is the first time I've come across this type of call out. I understand a bit about how it works, but need help with the execution.
Could someone, please, walk me through the general steps I'd take…
Feature control frame asks Position of ID to Top Plane -A- and -B-. Datum -B- is 3 datum target points all at different radial distances. Would Datum -B- just be reported as separate points or do you combine all 3 for a feature? Thanks for any help.
Good morning all,
I have a question in regards to a true position stack up.
I am using a CAD model to probe the part but my Z nominal is incorrect. which should be the nominal distance from plane A to the hole so it is throwing my tolerance off…
Good afternoon all,
I am trying to set up a quick program to measure a true position call out for a part we are running at the shop. it is a small bushing and the TP call out is the O.D. cylinder to the I.D. cylinder (datum A) and a perpendicular…
Need help!! Not sure why PC-DMIS keeps giving me bad results. I have created different alignments, different hits, different workplanes and views but PC-DMIS still gives me wrong numbers. Any suggestions on what is going on?
On the blueprint I have…
All of my FAIRs and FIRs are bubbled such that the True Position and Size are two different bubbles and require two different
labeled dimensional readouts on my reports; thus, I make separate dimensions for size (diameter in this case) and true position…
I Have trouble when showing True Position on FCF,
There is some information i want to hide or delete, that is location on Datum which shown in Position tab, that information come when i add secondary and tertiery datum with MMC or LMC on True Position…
