Dataview direction error for trim points??

Hello,
I'm having trouble with trim points on dataview. When dataview reports on some trim points their "T" value reports F/A when the vector is c/c. It only makes this mistake when the prehit direction (form) deviates further than the trim. So if the trim is @ nominal and trim point is in the Y the report would say F/A beside dataview trend graph on that point because the prehit measures the form with a deviation?!?!

Is there a quick fix for this?

Parents

jimmyD over 15 years ago

IF you are NOT reporting the FORM ERROR with those edge points, turn on GAP ONLY for the XYZT dimensions for the edge points. It acts like SNAP does for vector points. I still allows the surface sample hit to determine the depth of touch, but then it "projects" back to the nominal surface. That should fix it.

Thanks for the quick reply, I'll giver a whirl. You look like Dolph Lundgren in that photo...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

jimmyD over 15 years ago

IF you are NOT reporting the FORM ERROR with those edge points, turn on GAP ONLY for the XYZT dimensions for the edge points. It acts like SNAP does for vector points. I still allows the surface sample hit to determine the depth of touch, but then it "projects" back to the nominal surface. That should fix it.

Thanks for the quick reply, I'll giver a whirl. You look like Dolph Lundgren in that photo...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data