I was wondering if anybody has had an issue with Datapage + 2012 not seeing the Portlock sometimes? Some days when i am running a part in Dmis and try to open Datapage + i get a pop up that says "You do not have a portlock. Datapage + cannot continue". If i wait until the inspection program is finished running and do a computer restart, Datapage + opens. It doesn't do this all the time. Does anybody know if there is a setting i need to check/change to correct this.
Thank you in advance.
do you have two portlocks?
if so then update the safenet drivers to handle both portlocks at the same time and make sure pcdmis can handle it.
if you only have one portlock then get hex to replace it as its on the way out.
Im having an issue like that,
Im running pc-dmis 2013 off line dongle, and have just purchased datapage+ on another dongle so I can use datapage on another pc as well as mine.
How do I update safenet drivers to handle both portlocks?
Can I even use two dongles at the same time?
Im having an issue like that, Im running pc-dmis 2013 off line dongle, and have just purchased datapage+ on another dongle so I can use datapage on another pc as well as mine. How do I update safenet drivers to handle both portlocks? Can I even use two dongles at the same time?
No you cant have two pcdmis/wilcox dongles in one pc and expect them both to work together.
I have a similar issue with pcdmis blade.
I have to run blade in a virtual machine to have both portlocks work on one pc.
